Author Topic: 1995 SR couple of questions  (Read 1909 times)

Minerrick

  • Member
  • Posts: 15
  • I'm new here!
1995 SR couple of questions
« on: December 30, 2018, 09:17:11 AM »
1. I have a buzzing type rattle that appears to be near the left side windshield when the vehicle get up to about 60 mph. Anyone else have this issue and a fix?

2. Once again I am confounded by the rear bench seat. I have spent hours trying to figure out how to fold it forward. Can someone give me a step by step instruction on how to fold that thing forward? It's such a pain, I am considering taking it out - once I figure out how to fold it forward.

that_guy_eric

  • Member
  • Posts: 25
  • I'm new here!
Re: 1995 SR couple of questions
« Reply #1 on: December 30, 2018, 06:29:26 PM »
There is a video on youtube for the seats.

Minerrick

  • Member
  • Posts: 15
  • I'm new here!
Re: 1995 SR couple of questions
« Reply #2 on: December 30, 2018, 10:01:01 PM »
The video is for Gen 3- are the seat mechanisms the same?

Crumb

  • Member
  • Posts: 734
Re: 1995 SR couple of questions
« Reply #3 on: December 31, 2018, 05:44:32 AM »
The windshield trim clips may be broken.

that_guy_eric

  • Member
  • Posts: 25
  • I'm new here!
Re: 1995 SR couple of questions
« Reply #4 on: January 07, 2019, 10:07:07 PM »
The video is for Gen 3- are the seat mechanisms the same?

Google "montero bed" and it pulls right up.

Minerrick

  • Member
  • Posts: 15
  • I'm new here!
Re: 1995 SR couple of questions
« Reply #5 on: January 14, 2019, 11:39:32 PM »
What - pray tell- is a windshield clip?

RyanY

  • Member
  • Posts: 52
  • I'm new here!
Re: 1995 SR couple of questions
« Reply #6 on: January 24, 2019, 05:04:55 PM »
It's most likely your windshield side molding - the vertical black plastic/rubber piece that runs up the side of the windshield. They are still available new from Mitsubishi - I just replaced all my moldings when I had a new windshield installed. It's attached by plastic clips underneath which are likely brittle and cracked, and will probably break further if you try to remove it.